多項選擇題

Based on the show spanning-tree vlan 200 output shown in the exhibit, 
which two statements about the STP process for VLAN 200 are true? ()

A.BPDUs will be sent out every two seconds.
B.The time spent in the listening state will be 30 seconds.
C.The time spent in the learning state will be 15 seconds.
D.The maximum length of time that the BPDU information will be saved is 30 seconds.
E.This switch is the root bridge for VLAN 200.
F.BPDUs will be sent out every 10 seconds.


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題Which three statements about STP timers are true?()

A.STP timers values (hello, forward delay, max age) are included in each BPDU.
B.A switch is not concerned about its local configuration of the STP timers values. It will only consider the value of the STP timers contained in the BPDU it is receiving.
C.To successfully exchange BPDUs between two switches, their STP timers value (hello, forward delay, max age) must be the same.
D.If any STP timer value (hello, forward delay, max age) needs to be changed, it should at least be changed on the root bridge and backup root bridge.
E.On a switched network with a small network diameter, the STP hello timer can be tuned to a lower value to decrease the load on the switch CPU.
F.The root bridge passes the timer information in BPDUs to all routers in the Layer 3 configuration.

3.單項選擇題

Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.
Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()

A.DSW11(config)# spanning-tree vlan 1 priority 4096
B.DSW12(config)# set spanning-tree priority 4096
C.ASW13(config)# spanning-tree vlan 1 priority 4096
D.DSW11(config)# set spanning-tree priority 4096
E.DSW12(config)# spanning-tree vlan 1 priority 4096
F.ASW13(config)# set spanning-tree priority 4096

4.多項選擇題

Given the above diagram and assuming that STP is enabled on all switch devices, 
which two statements are true?()

A.DSW11 will be elected the root bridge.
B.DSW12 will be elected the root bridge.
C.ASW13 will be elected the root bridge.
D.P3/1 will be elected the nondesignated port.
E.P2/2 will be elected the nondesignated port.
F.P3/2 will be elected the nondesignated port.

5.多項選擇題Which two statements concerning STP state changes are true? ()

A.Upon bootup,a port transitions from blocking to forwarding because it assumes itself as root.
B.Upon bootup,a port transitions from blocking to listening because it assumes itself as root.
C.Upon bootup,a port transitions from listening to forwarding because it assumes itself as root.
D.If a forwarding port receives no BPDUs by the max_age time limit, it will transition to listening.
E.If a forwarding port receives an inferior BPDU, it will transition to listening.
F.If a blocked port receives no BPDUs by the max_age time limit, it will transition to listening.

6.多項選擇題

In a customer’s network, VLAN Trunking Protocol (VTP) is running with a domain named main1. VLANs 1,2,3,4,5,10,20 are active on the network. Suddenly the whole network goes down. No traffic is being passed on VLANs 2,3,4,5,10,20, however traffic passes on VLAN 1 and indicates all switches are operational. Right before the network problem occurred, a switch named TEST1 was added to the network. 
What three configuration issues on TEST1 could be causing the network outage?()


A.TEST1 is configured as a VTP server with a different domain name.
B.TEST1 is not configured to participate in VTP.
C.TEST1 is configured as a VTP server with the domain name main1.
D.TEST1 has a lower VTP configuration revision than the current VTP revision.
E.TEST1 has a higher VTP configuration revision than the current VTP revision.
F.TEST1 is configured with only VLAN1.


9.判斷題

Spanning-Tree Protocol is a link management protocol that provides path redundancy while 
preventing undesirable loops in the network. For an Ethernet network to function properly, only one active path can exist between two stations. Multiple active paths between stations cause loops in the network. If a loop exists in the network topology, the potential exists for duplication of messages. When loops occur, some switches see stations appear on both sides of the switch. This condition confuses the forwarding algorithm and allows duplicate frames to be forwarded. To provide path redundancy, Spanning-Tree Protocol defines a tree that spans all switches in an extended network. Spanning-Tree Protocol forces certain redundant data paths
into a standby (blocked) state. If one network segment in the Spanning-Tree Protocol becomes unreachable, or if Spanning-Tree Protocol costs change, the spanning-tree algorithm reconfigures the spanning-tree topology and reestablishes the link by activating the standby path. Spanning-Tree Protocol operation is transparent to end stations, which are unaware whether they are connected to a single LAN segment or a switched LAN of multiple segments.There is a lab about STP in Cisco CCNP 642-812 / 642- 892 exam.


Requirements: 
You will configure FastEthernet ports 0/12 through 0/24 for users who belong to VLAN 20. Also, all VLAN and VTP configurations are to be completed in global configuration mode as VLAN database mode is being deprecated by Cisco. You are required to accomplish the following tasks: 
1. Ensure the switch does not participate in VTP but forwards VTP advertisements received on trunk ports. 
2. Ensure all non-trunking interfaces (Fa0/1 to Fa0/24) transition immediately to the forwarding state of Spanning-Tree. 
3. Ensure all FastEthernet interfaces are in a permanent non-trunking mode. 
4. Place FastEthernet interfaces 0/12 through 0/24 in VLAN 20

10.判斷題

Acme is a small shipping company that has an existing enterprise network comprised of 2 
switches;DSW1 and ASW2. The topology diagram indicates their layer 2 mapping. VLAN 40 is a new VLAN that will be used to provide the shipping personnel access to the server. For security reasons, it is necessary to restrict access to VLAN 20 in the following manner: 
- Users connecting to ASW1’s port must be authenticate before they are given access to the network. -Authentication is to be done via a Radius server:
- Radius server host: 172.120.39.46
-Radius key: rad123 
- Authentication should be implemented as close to the host device possible. 
- Devices on VLAN 20 are restricted to in the address range of 172.120.40.0/24. 
- Packets from devices in the address range of 172.120.40.0/24 should be passed on VLAN 20. 
- Packets from devices in any other address range should be dropped on VLAN 20. 
- Filtering should be implemented as close to the server farm as possible. 
The Radius server and application servers will be installed at a future date. You have been tasked with implementing the above access control as a pre-condition to installing the servers. You must use the available IOS switch features.
 

最新試題

Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1? ()

題型:單項選擇題

What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()

題型:單項選擇題

Which three statements about STP timers are true?()

題型:多項選擇題

Which statement is correct about the use of the virtual interface on a WLC ?()

題型:單項選擇題

During routine maintenance, it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time, DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ? ()

題型:單項選擇題

Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result?()

題型:單項選擇題

Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?()

題型:單項選擇題

Refer to the exhibit. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link?()

題型:多項選擇題

Based on the show spanning-tree vlan 200 output shown in the exhibit, which two statements about the STP process for VLAN 200 are true? ()

題型:多項選擇題

Which three statements are true of the Link Aggregation Control Protocol (LACP)?()

題型:多項選擇題