You are a senior network administrator at TestKing and your trusty junior administrator tells you that he failed his task of adding VLAN 50 to a Catalyst switch in the network. You enter in the 'show vtp status' command and get this output:
TK2# show vtp status
VTP Version :2
Configuration Revision :7
Maximum VLANs supported local :68
Number of existing VLANs :8
VTP Operating Mode :Client
VTP Domain Name :corp
VTP Pruning Mode :Disabled
VTP V2 Mode :Disabled
VTP Traps Generation :Disabled
MD5 digest :0x22 0xF3 0x1A
Configuration last modified by 172.18.22.15 at 5-28-03 1t:53:20
What commands must be issued on this switch to add VLAN 50 to the database?()
A. TK2(config-if)# switchport access vlan 50
B. TK2(vlan)# vtp server
C. TK2(config)# config-revision 20
D. TK2(config)# vlan 50 name Tech
E. TK2(vlan)# vlan 50
F. TK2(vlan)# switchport trunk vlan 50
您可能感興趣的試卷
你可能感興趣的試題
There are 2 switches in the Testking LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link.
Which of the conditions below would verify trunk and VLAN operation?()
A. Host 1 on VLAN 1 can ping Host 2 on VLAN 1
B. Host 1 on VLAN 1 can ping Host 4 on VLAN 2
C. Host 1 on VLAN 1 can not ping Host 2 on VLAN 1
D. Host 4 on VLAN 2 can not ping Host 1 on VLAN 1
E. Host 4 on VLAN 2 can ping Host 2 on VLAN 2
A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.
In which OSI layer is the problem most likely occurring?()
A. Physical
B. Data link
C. Network layer
D. Transport layer
E. Application layer
A.Application
B.Presentation
C.Session
D.Transport
E.Network
F.Data-Link
A. Application
B. Presentation
C. Session
D. Transport
E. Internet
F. Data Link
G. Physical
A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer
A. show ip links
B. show cdp neighbor
C. show cdp neighbor detail
D. show ip clients
E. show ip route
F. None of the above
A. to identify valid numbers for incoming calls
B. to define the type of ISDN switch at the central office
C. to specify the list of outgoing phone numbers used by the router
D. to associate a dial configuration with a physical interface
E. to define interesting traffic that will enable the link
A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above
A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.
A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.
最新試題
What is the subnetwork address for a host with IP address 201.100.5.68/28?()
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?()
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? ()
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()
Which of the following correctly describe steps in the OSI data encapsulation process?()
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?()
Which command is used to display the placement and direction of an IP access control list on a router?()
Which statement describes the rule of split horizon?()
Which connections allow the use of full-duplex Ethernet?()