A. Only routers can split boundaries (horizons) between concentric networks.
B. All distance vector protocols require fall back routers that may cause momentary loops as the topology changes.
C. Networks can only remain fully converged if all information about routers is sent out all active interfaces.
D. Information about a route should not be sent back in the direction from which the original update come.
E. Each AS must keep routing tables converged to prevent dead routes from being advertised across the AS boundary.
您可能感興趣的試卷
你可能感興趣的試題
A. The default gateway is configured on a different subnet form this host.
B. The host is a member of the fifth usable subnet of the 192.168.16.0 network.
C. The subnetwork address for this host is 192.168.16.160/28.
D. The address of the next higher subnet is 192.168.16.192.
E. The address of the router interface that is attached to this subnetwork is 192.168.16.190.
F. There are 60 usable host addresses on this subnet.
A. A command that is available in every release of IOS, regardless of the version or deployment status.
B. A command that can be entered in any configuration mode.
C. A command that is universal in application and supports all protocols.
D. A command that is implemented in all foreign and domestic IOS version.
E. A command that is set once and affects the entire router.
A. Store-and-forward switching
B. Microsegmentation
C. Transparent bridging
D. Fragment-free switching
E. Virtual LANs
F. Cut-through switching
A. Optional authentication phase, link establishment phase, network layer protocol phase.
B. Network layer protocol phase, link establishment phase, optional authentication phase.
C. Network layer protocol phase, optional authentication phase, link establishment phase.
D. Link establishment phase, network layer protocol phase, optional authentication phase.
E. Link establishment phase, optional authentication phase, network layer protocol phase.
F. Optional authentication phase, network layer protocol phase, link establishment phase.
A. DLCI
B. BECN
C. FECN
D. LMI
E. CIR
F. DE
A. Provide common view of entire topology
B. Exchange routing tables with neighbors.
C. Calculates shortest path.
D. Utilizes event triggered updates.
E. Utilizes frequent periodic updates.
A. Use of full duplex mode.
B. Creation of new collision domain.
C. Creation of new broadcast domain.
D. Addition of hub to the network.
E. Use of switches in the network.
F. Amount of ARP or IPX SAP traffic.
A. Transport layer divides a data stream into segments & adds reliability & flow control information
B. Data link layer adds physical source & destination address & an FCS to the segment
C. Packets are created when the network layer encapsulate a frame with source & destination host address& protocol related control information
D. Packets are created when the network layers adds layers 3 address & control information to a segment
E. The presentation layer translated bits into bits into voltages for transmission across the physical link
A. The Boot IOS Code is Located in the NVRAM.
B. Check NVRAM for boot system Commands.
C. Bypass NVRAM Configurations.
D. Boot the IOS Code Located in ROM.
E. Perform a Password Recovery.
F. Bypass The Code In ROM.
A. show CHAP authentication
B. show interface serial 0
C. debug PPP authentication
D. debug CHAP authentication
E. show PPP authentication CHAP
最新試題
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?（）
What feature of a networks switch allows an administrative to create separate broadcast domains?（）
Which command is used to display the placement and direction of an IP access control list on a router?（）
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?（）
Which characteristics are representative of a link-state routing protocol?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
What is a global command?（）
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）