多項選擇題Which statements are true about EIGRP successor routes?（）

A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題You are troubleshooting a frame relay connection and wish to view the LMI traffic stats. Which command should you issue?（）

A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.

4.單項選擇題You have just obtained a modular Cisco router with 2 serial connections and a BRI/U interface. What other physical piece of hardware is required in order to establish an ISDN connection?（）

A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.

7.單項選擇題Which of the following Frame-Relay encapsulation commands would you use, if you had to connect your Cisco router to a non-Cisco router?（）

A. TestKRouter(config-if)# Encapsulation frame-relay dot1q
B. TestKRouter(config-if)# Encapsulation frame-relay aal5snap
C. TestKRouter(config-if)# Encapsulation frame-relay ietf
D. TestKRouter(config-if)# Encapsulation frame-relay isl
E. None of the above

8.單項選擇題A new frame-relay network is being implemented and inverse ARP does not appear to be operating correctly. Which alternative command can be used to provide connectivity?（）

A. frame-relay arp
B. frame-relay map
C. frame-relay interface-dlci
D. frame-relay lmi-type
E. frame-relay pvc

9.單項選擇題When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）

A. The local DLCI on each subinterface of the Frame Relay.
B. The Frame Relay encapsulation on the physical interface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point

10.多項選擇題A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?（）

A. Router# ping 192.168.13.26
B. Router# debug access-list 172
C. Router# show open ports 192.168.13.26
D. Router# show access-list
E. Router# show ip interface