CCNP系列認證章節(jié)練習(2020.04.12)

Ten routers, R1 through R10, connect in a partial mesh over Frame Relay. For the mesh, R1 and R2 have PVCs connected to all other routers, but Routers R3 through R10 act as branch routers, with only two PVCs - one to R1 and one to R2. The routers u se IP subnet 10.1.1.0/24, with addresses 10.1.1.1, 10.1.1.2, and so on, through 10.1.1.10, respectively. The routers all use Inverse ARP to learn Frame Relay mapping information. All routers use a multipoint subinterface with network type point - tomultip oint nonbroadcast. A co - worker's implementation plan lists lots of configuration commands related to this design. The design states that all hosts should be able to ping all other hosts.
Which commands are required for proper functioning of OSPF in this case?（）

R1 has correctly configured EIGRP to filter routes using a route map named question. The configuration that follows shows the entire route map and related configuration. Which of the following is true regarding the filtering action on prefix 10.10.10.0/24 in this case?（）
route - map question deny 10
match ip address 1
route - map question permit 20
match ip address prefix- list fred
!
access - list 1 deny 10.10.10.0 0.0.0.255
ip prefix - list fred permit 10.10.10.0/23 le 25

Refer to the exhibit. Both host stations are part of the same subnet but are in different VLANs. On  the basis of the information presented in the exhibit， 
which statement is true about an attempt to  ping from host to host？  （）