A. dispersion
B. Optical SNR
C. span attenuation
D. four wave mixing
E. receiver sensitivity
您可能感興趣的試卷
你可能感興趣的試題
A. 0 mW
B. 1 mW
C. 10 mW
D. 1.5 mW
A. lower cost
B. higher chirp
C. easier to manufacture
D. higher dispersion tolerance
E. higher optical signal-to-noise ratio
A. OSNR
B. dispersion
C. light skew
D. attenuation
A. amplifier
B. attenuator
C. regenerator
D. light emitter
E. optical switch
F. optical receiver
G. fiber-optic cable
A. OSNR
B. dispersion
C. attenuation
D. power budget
E. amplifier spacing
F. four wave mixing
A. PIN photodiodes
B. zero-chirped lasers
C. Erbium-doped fiber amplifiers
D. dispersion compensating fiber
E. dispersion compensating Bragg grating
A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).
A. low optical powe
B. high optical power
C. few optical channels
D. many optical channels
E. low chromatic dispersion
F. high chromatic dispersion
G. too much power differential in the optical channels
Given the formula: (Fiber Attenuation * Km) + (Splice Attenuation * # of Splices) + (Connector Attenuation * # of Connectors) + (Optical Fiber or OADM) + Buffer(Fiber aging)) With regard to SONET/SDH optical calculations,
what will the given formula provide?()
A. fiber loss
B. OSNR level
C. post amplification
D. index of reflection
E. index of refraction
F. power post amplification budget
Click the Exhibit button.
Which type of multiplexer is shown in the exhibit?()
A. Thin Film filter
B. Fiber Bragg Grating
C. Arrayed Wave Guide
D. Erbium fiber amplifier
最新試題
In order to avoid misconnections due to a failed node in an MS-SPRing, Alarm Indication Signals (AISs) are sent on every channel normally terminating in that node. What is the name of this process?()
If node 2 is accepting line timing from node 1, node 2 will send () to node 1 as its SSM messge.
The dispersion of a non-zero dispersion shifted fiber is 6 ps/nm*km at 1550 nm and 10 ps/nm*km at 1610 nm. What is the minimum dispersion compensation required if an L-Band DWDM signal travels through 200 km of fiber and has a dispersion tolerance of 1800 ps/nm?()
What is an advantage of an externally modulated laser over a directly modulated laser? ()
In SDH, what is the name of the embedded Data Communication Channel (DCC) in bytes D1-D3?()
Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?()
In the OSNR model for EDFA amplifiers, SNR OUT = 1/(1/SNR IN + FhvB/P IN ), what does SNR IN represent?()
On an ONS 15454 node you can tunnel a(n) ().
The ONS 15216 is a 32-channel system. The ONS 15216 OADMs are capable of adding and dropping one, two, or four channels. How are the OADMs provisioned to add and drop specific channels?()
What three in combination are factors that can cause four-wave mixing in fiber-optic cables?()