A.IETF
B.PFC
C.ASIC
D.TCAM
您可能感興趣的試卷
你可能感興趣的試題
A. Features such as UplinkFast and BackboneFast are compatible with RSTP.
B. An RSTP that is based on Cisco products generally performs better than the Cisco proprietary 802.1D enhancements.
C. Cisco proprietary enhancements are not transparent.
D. Information about port roles is sent to all switches.
E. RSTPs that are based on Cisco products require no additional configuration.
A. Implement threshold monitoring using RMON.
B. Implement monitoring using SNMP or RMON.
C. Poll and record specific SNMP MIB objects from the device.
D. Verify that SNMP MIB is supported in the relevant core device.
A. TCP-based hello packets
B. the impact of flapping links if timers are too low
C. a shared single interface
D. the ability to track serial interfaces
E. UDP-based hello packets
A. Cisco is focusing on Cisco Validated Designs as a means to driving integrated networks.
B. Cisco is focusing on the PIN architecture as a means to driving integrated networks.
C. The Cisco PIN architecture is a critical mechanism for supporting integrated markets because it can be implemented quickly.
D. The Cisco Validated Designs program provides critical mechanisms for supporting integrated markets because the mechanisms can be implemented quickly.
E. Cisco Validated Designs can be implemented quickly without customer input.
A. start LDP
B. enable CEF switching
C. configure the MPLS ID
D. disable IP TTL propagation
E. configure conditional label advertising
F. enable label switching on frame mode interfaces
A. show status
B. show hardware
C. show inventory
D. show environment
A. remote scheduling of software distribution
B. comprehensive logs, reports, and graphs
C. automatic discovery of Cisco WAEs
D. content pre-positioning
A. IS-IS, EIGRP, SSO, BGP
B. ISSU, OSPF, IS-IS
C. IETF, OSPF, ISSU
D. EIGRP, BGP, OSPF, IS-IS
A. An information trap is sent to the SNMP server.
B. Informational and debug messages are logged to the syslog server.
C. All messages are sent to the logging host, where selections are made.
D. All messages from emergencies to informational are sent to the logging host.
A. reset of the primary supervisor
B. manual switchover from standby to active supervisor
C. manual switchover from active to standby supervisor
D. automatic switchover from active to standby on primary supervisor failure
最新試題
What is the maximum number of Cisco Catalyst 3750 Series Switches that can be united into a single manageable unit using the Cisco StackWise technology?（）
When a Cisco router is configured for SSH, it acts as an （）?
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
Which command is used to view IPv6 parameters related to the BGP process?（）
As an experienced technician, you are responsible for Technical Support in your company. One of the trainees is asking you which Cisco VPN Acceleration Module for Cisco 7200 Series routers and the Cisco 7301 provides high-performance encryption/compression and supports the latest encryption standard.Which of the following will answer his question?（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）