A. The switch that will share its VLAN configuration must be in VTP server mode.
B. The switches must be in the same VTP domain.
C. The switch that will share the VLAN information must be configured as the root bridge.
D. The switches must be connected over VLAN trunks.
E. The switches must be configured to use the same STP version.
F. The switches must have VTP pruning activated.

A. By default, all defined VLANs are allowed on the trunk.
B. Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C. Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D. Each single VLAN, or VLAN range, must be specified with the vlan database command.

A. They increase the size of collision domains.
B. They allow logical grouping of users by function.
C. They can enhance network security,
D. The increase the size of broadcast domains while decreasing the number of the broadcast domains.
E. The increase the number of broadcast domains while decreasing the size of the broadcast domains.
F. They simplify switch administration.

A. Switch(vlan)# mode trunk
B. Switch(config)# switchport access mode trunk
C. Switch(config-if)# switchport mode trunk
D. Switch(config-if)# switchport trunk encapsulation dot1q
E. Switch(config)# switchport access mode 1
F. Switch(vlan)# trunk encapsulation dot1q

A. VLANs allow access to network services based on department, not physical location.
B. VLANs utilize packet filtering to enhance network security.
C. VLANs provide a low-latency, high bandwidth internetworking alternative.
D. VLANs provide a method of communication between IP addresses in large networks.
E. VLANs establish segmented broadcast domains in switched networks.
F. VLANs can greatly simplify adding, moving, or changing hosts on the network.

A. VLANs logically divide a switch into multiple, independent switches at Layer 2.
B. Trunk links can carry traffic for multiple VLANs.
C. VLAN implementation significantly increases traffic due to added trunking information.
D. VLANs can span multiple switches.
E. VLANs typically decrease the number of switches needed

A. Set each end of the trunk line to IEEE 802.1Q encapsulation.
B. Set the same VTP management domain name on both switches.
C. Set all ports on the two switched as access ports.
D. Configure one of the two switches as a VTP server.
E. Connect the two switches using a rollover cable.
F. Use a router to forward VTP traffic between the VLANs.

A. Transparent
B. Server
C. Auto
D. Client
E. User

A.VTP
B.802.1Q
C.LLC
D.ISL
E.CDP
F.PAP

A. Blocking
B. Auto
C. Desirable
D. On
E. Transparent
F. Learning