A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
您可能感興趣的試卷
你可能感興趣的試題
A.The router will use the static route.
B.The router will use the OSPF route.
C.The router will use the EIGRP route.
D.The router will load balance and use all three routes.
A.neighbor table
B.SPF table
C.RTP table
D.topology table
E.query table
F.DUAL table
A.1024
B.2046
C.4094
D.4096
E.8190
A.assigning a private IP address to the AP
B.changing the default SSID value
C.configuring a new administrator password
D.changing the mixed mode setting to single mode
E.configuring traffic filtering
A.The switch will not forward unicast frames.
B.The switch will forward the frame to a specific port.
C.The switch will return a copy of the frame out the source port.
D.The switch will remove the destination MAC from the switch table.
E.The switch will forward the frame to all ports except the port on which it was received.
A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction
A.default gateway
B.DNS servers
C.FTP server
D.helper address
E.subnet mask
F.TFTP server
A.It sends data in clear text format.
B.It is no longer supported on Cisco network devices.
C.It is more secure than SSH
D.It requires an enterprise license in order to be implemented.
E.It requires that the destination device be configured to support Telnet connections.
A.Switches take less time to process frames than hubs take.
B.Switches do not forward broadcasts.
C.Hubs can filter frames.
D.Using hubs can increase the amount of bandwidth available to hosts.
E.Switches increase the number of collision domains in the network.
A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.
最新試題
On which options are standard access list based?（）
Which statement describes the rule of split horizon?（）
What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
What is the purpose of the cisco Vlan Trunking protocol?（）
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）