請參見圖示。當收到下列幀將會怎么做？（）
A.Router1的將剝離的源MAC地址，并將其與MAC地址0000.0c36.6965取代。
B.Router1的將剝離的源IP地址，并將其與IP地址192.168.40.1取代。
C.router1將剝離的目的MAC地址，并將其與MAC地址代替0000.0c07.4320。
D.router1將剝離的目的IP地址，并將其與192.168.40.1的IP地址替換。
E.Router1的將轉發數據包輸出接口的FastEthernet0/1。
F.router1將轉發數據包輸出接口的FastEthernet0/2。
您可能感興趣的試卷
你可能感興趣的試題
A.4to6 routing
B.6to4 routing
C.binary routing
D.dual-stack routing
E.NextGen routing
A.Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B.Gateway-Router is configured to only receive RIPv2 updates.
C.Gateway-router is configured to receive only RIPv1 updates.
D.Branch-Router1 is configured to only send RIPv1 updates
A.A dynamically learned MAC address is saved in the startup-configuration file.
B.A dynamically learned MAC address is saved in the running-configuration file.
C.A dynamically learned MAC address is saved in the VLAN database.
D.Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.
E.Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.
A.172.16.0.0/18
B.172.16.0.0/16
C.172.16.0.0/20
D.172.16.0.0/21
A.added security
B.dedicated bandwidth
C.provides segmentation
D.allows switches to route traffic between subinterfaces
E.contains collisions
Refer to the exhibit.Assume that the routing protocol referenced in each choice below is configured with its default settings and the given routing protocol is running on all the routers. Which two conditional statements accurately state the path that will be chosen between networks 10.1.0.0 and 10.3.2.0 for the routing protocol mentioned？ （）
A.If OSPF is the routing protocol， the path will be from R1 to R3 to R4 to R5.
B.If OSPF is the routing protocol， the path will be from R1 to R2 to R5.
C.If OSPF is the routing protocol， the path will be from R1 to R5.
D.If RIPv2 is the routing protocol， the path will be from R1 to R3 to R4 to R5.
E.If RIPv2 is the routing protocol， the path will be from R1 to R5.
A.2 through 1001
B.1 through 1001
C.1 through 1002
D.2 through 1005
Refer to the exhibit. SW1 and SW2 have default configurations. What will happen if host 1 sends a broadcast？（）
A. Hosts 2， 3， and 4 will receive the broadcast.
B. Hosts 1， 2， 3， and 4 will receive the broadcast.
C. Host 2 and the Fa0/0 interface of R1 will receive the broadcast.
D. Hosts 1， 2 and the Fa0/0 interface of R1 will receive the broadcast.
E. Hosts 1， 2， 3， 4 and interface Fa0/0 of R1 will receive the broadcast.
F. Hosts 2， 3， 4， and interfaces Fa0/0 and Fa0/1 of R1 will receive the broadcast.
A.(config-if)#authentication ppp chap fallback ppp
B.(config-if)#authentication ppp chap pap
C.(config-if)#ppp authentication chap pap
D.(config-if)#ppp authentication chap fallback ppp
A.Bandwidth,Delay,and MTU
B.Bandwidth
C.Bandwidth and MTU
D.Bandwidth , MTU,Reliability,Delay,and Load
最新試題
要將數據包發送到遠程網絡，應使用哪種設備？（）
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接？（）
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論？（）
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€(gè)廣播域？（）
在Cisco IOS 設備中，啟動配置文件存儲于何處？（）
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述，哪兩項是正確的？（）
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么？（）
PC 無法連接到任何遠程網站，無法ping 通其默認網關，也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常？（）
請參見圖示。公司路由器由于故障被更換。更換路由器之后，Education 辦公室內的主機C 和D 能夠相互ping 通，但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么？（）
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲行枰嗌賯€(gè)邏輯地址范圍？（）