單項選擇題Which parameter or parameters are used to calculate OSPF cost in cisco routers?()

A.Bandwidth,Delay,and MTU
B.Bandwidth
C.Bandwidth and MTU
D.Bandwidth , MTU,Reliability,Delay,and Load


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

Refer to the exhibit. A packet with a source IP address of 192.168.2.4 and a destination IP address of 10.1.1.4 arrives at the HokesB router. What action does the router take?()

A. forwards the received packet out the Serial0/0 interface
B. forwards a packet containing an EIGRP advertisement out the Serial0/1 interface 
C. forwards a packet containing an ICMP message out the FastEthernet0/0 interface
D. forwards a packet containing an ARP request out the FastEthernet0/1 interface

2.多項選擇題What are two advantages of Layer 2 Ethernet switches over hubs?()

A.decreasing the number of collision domains
B.filtering frames based on MAC addresses
C.allowing simultaneous frame transmissions
D.increasing the size of broadcast domains
E.increasing the maximum length of UTP cabling between devices

4.多項選擇題What can be done to secure the virtual terminal interfaces on a router?()

A.Administratively shut down the interface.
B.Physically secure the interface.
C.Create an access list and apply it to the virtual terminal interfaces with the access-group command.
D.Configure a virtual terminal password and login process.
E.Enter an access list and apply it to the virtual terminal interfaces using the access-class command.

5.多項選擇題Which two statements apply to dynamic access lists?()

A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users.

6.多項選擇題Which two of these are characteristics of the 802.1Q protocol?()

A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.

8.多項選擇題Which two data link layers are supported by cisco ios software for IPv6?()

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC

9.單項選擇題

Refer to the exhibit.Give this output for SwitchC, what should the network administrator’s next action be?()

A.Check the trunk encapsulation mode for SwitchC’s fa0/1 port.
B.Check the duplex mode for SwitchC’s fa0/1 port.
C.Check the duplex mode for SwitchA’s fa0/2 port.
D.Check the trunk encapsulation mode for SwitchA’s fa0/2 port.

10.單項選擇題Which PPP subprotocol negotiates authentication options?()

A.NCP
B.LCP
C.ISDN
D.DLCI
E.SLIP

最新試題

何時必須使用clock rate 命令配置路由器串行接口?()

題型:單項選擇題

請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()

題型:單項選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:單項選擇題

請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()

題型:單項選擇題

請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口?()

題型:單項選擇題

請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet??梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址?()

題型:單項選擇題

傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()

題型:單項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€(gè)廣播域?()

題型:單項選擇題

請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()

題型:單項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:單項選擇題