A.24
B.4
C.3
D.16
您可能感興趣的試卷
你可能感興趣的試題
A.B514：82C3：0029：：EC7A：0000：EC72
B.B514：82C3：0029：EC7A：EC72
C.B514：82C3：：0029：EC7A：0：EC72
D.B514：82C3：：0029：EC7A：EC72
The Frame Relay network in the diagram is not functioning properly. What is the cause of the problem?（）
A.The Gallant router has the wrong LMI type configured
B.Inverse ARP is providing the wrong PVC information to the Gallant router
C.The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command
D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct
E.The IP address on the serial interface of the Attalla router is configured incorrectly
A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the subinterface B
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic
C.Configure many sub-interfaces on the same subnet
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces
A. buffering
B. cut-through
C. windowing
D. congestion avoidance
E. load balancing
A.A CSU/DSU terminates a digital local loop
B.A modem terminates a digital local loop
C.A CSU/DSU terminates an analog local loop
D.A modem terminates an analog local loop
E.A router is commonly considered a DTE device
F.A router is commonly considered a DCE device
A. 115.64.8.32
B. 115.64.7.64
C. 115.64.6.255
D. 115.64.3.255
E. 115.64.5.128
F. 115.64.12.128
A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction
A.statically map IPV4 address to IPV6 addresses
B.configuration IPv4 tunnels between IPV6 islands
C.use DHCPv6 to map IPV4 addresses to IPV6 addresses
D.use proxying and translation to translate IPV6 packets into IPV4 packets
E.configure IPV6 directly
F.enable dual-stack routing
A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint
E.broadcast point-to-multipoint
A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations
最新試題
在路由器上使用Router#copy running-config startup-config 命令會產生什么效果？（）
請參見圖示。公司路由器由于故障被更換。更換路由器之后，Education 辦公室內的主機C 和D 能夠相互ping 通，但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么？（）
請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置？（）
請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間，路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時，它的源MAC 地址是什么？（）
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流？（）
OSI 模型的哪兩項功能在第2層實現？（）
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet?？梢詾槁酚善鹘涌赟0/0/0分配下列哪一個IP 地址？（）
請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中存在多少個廣播域？（）
請參見圖示。在網絡中，PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序？（）
PC 無法連接到任何遠程網站，無法ping 通其默認網關，也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常？（）