A. 115.64.8.32
B. 115.64.7.64
C. 115.64.6.255
D. 115.64.3.255
E. 115.64.5.128
F. 115.64.12.128
您可能感興趣的試卷
你可能感興趣的試題
A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction
A.statically map IPV4 address to IPV6 addresses
B.configuration IPv4 tunnels between IPV6 islands
C.use DHCPv6 to map IPV4 addresses to IPV6 addresses
D.use proxying and translation to translate IPV6 packets into IPV4 packets
E.configure IPV6 directly
F.enable dual-stack routing
A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint
E.broadcast point-to-multipoint
A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations
A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.
A.VTP
B.802.1Q
C.RSTP
D.STP
A.FTP traffic from 192.169.1.22 will be denied
B.No traffic, except for FTP traffic will be allowed to exit E0
C.FTP traffic from 192.169.1.9 to any host will be denied
D.All traffic exiting E0 will be denied
E.All FTP traffic to network 192.169.1.9/29 will be denied
A. hello packets
B. SAP messages sent by other routers
C. LSAs from other routers
D. beacons received on point-to-point links
E. routing tables received from other link-state routers
F. TTL packets from designated routers
Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured，what could be thecause of this problem？（）
A.HostA is not on the same subnet as its default gateway
B.The address of SwitchA is a subnet address
C.The Fa0/0 interface on RouterA is on a subnet that cannot be used
D.The serial interfaces of the routers are not on the same subnet
E.The Fa0/0 interface on RouterB is using a broadcast address
A.access-list 101 in
B.access-list 101 out
C.ip access-group 101 in
D.ip access-group 101 out
最新試題
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述，哪兩項是正確的？（）
OSI 模型的哪兩項功能在第2層實現？（）
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流？（）
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么？（）
下列哪些是私有IP 地址的地址范圍？（）
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程？（）
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet。可以為路由器接口S0/0/0分配下列哪一個IP 地址？（）
請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間，San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時，它的目的MAC 地址是什么？（）
請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確？（）
OSI 哪一層可提供有序的數據重構服務？（）