A.Core2(config)# interface f0/0  Core2(config-if)# ip address 192.168.1.10 255.255.255.248
B.Core2(config)# interface vlan 1 Core2(config-if)# ip address 192.168.1.11 255.255.255.248
C.Core2(config)# line con 0 Core2(config-line)# password cisco
D.Core2(config)# line vty 0 4 Core2(config-line)# password cisco
E.Core2(config)# ip default-gateway 192.168.1.9
F.Core2(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.8

A.a primary route，stored in the routing table
B.a backup route，stored in the routingt able
C.a backup route，stored in the topology table
D.A primary route，stored in the topology table

A.子網掩碼
B.源網絡地址
C.目的網絡地址
D.下一跳地址

A.應用層
B.表示層
C.會話層
D.傳輸層
E.網絡層
F.鏈路層
G.物理層

A.the session layer
B.the protocol layer
C.the data link layer
D.the access layer
E.the network layer
F.the application layer

A.It supports VLSM.
B.It is used to route between autonomous systems.
C.It confines network instability to one area of the network.
D.It increases routing overhead on the network.
E.It allows extensive control of routing updates.
F.It is simpler to configure than RIP v2.

A.Router C will use ICMP to inform Host 1 that Host 2 cannot be reached
B.Router C will use ICMP to inform Router B that Host 2 cannot be reached
C.Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be reached
D.Router C will send a Destination Unreachable message type
E.Router C will send a Router Selection message type
F.Router C will send a Source Quench message type

A.RIPng
B.OSPFv3
C.IS-IS for IPv6
D.static

A.hello packets
B.SAP messages sent by other routers
C.LSAs from other routers
D.beacons received on point-to-point links
E.routing tables received from other link-state routers
F.TTL packets from designated routers