A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
您可能感興趣的試卷
你可能感興趣的試題
A.100 mW, 24 Mb/s
B.100 mW, 18 Mb/s
C.25 mW, 18 Mb/s
D.3.2 mW, 54 Mb/s
A.In a multifloor building, the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor, without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
A.access point position, in feet, from a corner of the floor plan
B.SNR coverage map for 802.11a/n
C.data rate map for 802.11a/n
D.percent of coverage by signal
A.TIFF
B.DXF
C.PNG
D.DWG
A.per SSID
B.per access point
C.globally
D.per WLAN and radio
A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
A.rogue access point detection in the coverage area
B.multipath issues in the coverage area
C.number of VoWLAN users in the coverage cell
D.call capacity requirements of the coverage area
最新試題
Given the correct input parameters, the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses? ()
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas?()
In an outdoor bridge link, what is calculated by using this formula: transmitter power + antennagain - insertion OR cable loss()?
Which format can NOT be imported into Cisco WCS Planning Tool?()
When using a lightning arrestor, connect which type of ground wire to a good earth ground?()
What is a site survey best practice for location-based services?()
How should the transmit power on an access point and client each be set during a site survey?()
Which three device types are identified by Cisco Spectrum Expert Wi-Fi finding an Avg PulseDuration parameter?()
Which three items should the site survey documentation include?()
Which statement regarding the site-survey process is correct?()