Refer to the exhibit.
Why does the trust state of interface FastEthernet 0/3 show "not trusted"? ()
A.DSCP map needs to be configured for VOIP.
B.ToS has not been configured.
C.ToS has been misconfigured.
D.The command mls qos needs to be turned on in global configuration mode.
E.There is not a Cisco Phone attached to the interface.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.
What statement is true about the configuration on switch CAT1?()
A.The configuration establishes policed DSCP on ports Fa0/11 and Fa0/12 with values ranging from 8 to 56.
B.The configuration overrides 802.1p priorities on packets entering ports Fa0/11 and Fa0/12 with a value of 48.
C.Untagged Port VLAN ID (PVID) frames will carry voice traffic on VLAN 40.
D.Two IP phones with the MAC addresses of 0008.8595.d1a7 and 0007.8595.d2b7 are connected to CAT1 ports Fa0/11 and Fa0/12, respectively.
E.Security violation shutdown mode has been activated for ports Fa0/11 and Fa0/12.
F.The configuration overrides the Quality of Service value in packets entering ports Fa0/11 and Fa0/12 with a value of 45.
You need to configure a new Cisco router to be installed in the Company VOIP network.
Which three interface commands will configure the switch port to support a connected Cisco phone and to trust the CoS values received on the port if CDP discovers that a Cisco phone is attached? ()
A.switchport voice vlan vlan-id
B.mls qos trust device cisco-phone
C.switchport priority extend cos_value
D.mls qos trust cos
E.mls qos trust override cos
Refer to the exhibit.
Which three statements are true about trust boundaries in the campus network?()
A.Classification and markingoccur using 802.1ab QoS bits before reaching the trust boundary.
B.A device is trusted if it correctly declassifies packets.
C.A device is trusted if it correctly classifies packets.
D.Network trust boundaries are automatically configured in IOS version 12.3 and later.
E.The outermost trusted devices represent the trust boundary.
F.For scalability, classification should be done as close to the edge as possible.
Refer to the exhibit.
Which two statements are true about the required switch configurations to support a voice VLAN?()
A.CDP must be disabled on the switch port to prevent interference between CDP messages and voice traffic.
B.Port security cannot be configured on a port that is configured for a voice vlan.
C.Static secure MAC addresses should be configured on voice vlan ports to prevent access by devices other than IP phones.
D.CDP must be enabled on the switch port to allow configuration information to be passed to the IP phone.
E.Portfast must be enabled on the switch port.
F.802.1x authentication cannot be configured on a port configured for a voice vlan.
You have been tasked with setting a trust boundary on the Company network.
What is the basic function of this trust boundary?()
A. Trust boundaries are points in the network where Layer 2 CoS markings are converted to Layer 3 DSCP or IP precedence markings.
B. Trust boundaries are a point in the network where QoS functionality begins and ends.
C. Trust boundaries determine whether certain types of traffic can pass.
D. Trust boundaries are a point in the network where decisions about CoS markings on incoming packets are made.
E. None of the other alternatives apply
Refer to the exhibit. On basis of the configuration that is provided,
where will the trust boundary be established in this network? ()
A.at the PC
B.at the access switch
C.at the IP phone
D.at the distribution switch
You need to determine where the trust boundaries will be in a new Company VOIP design.
Which two statements are true about these trust boundaries?()
A.Trust boundaries are configured in the core of the network to provide the most efficient forwarding based upon QoS markings,
B.Setting trust boundaries at the edge of the network allows intermediate hop devices to administer QoS policies without detailed packet identification.
C.Trust boundaries are used to determine which QoS mechanism will be applied to the traffic.
D.At the trust boundaries, the untrusted traffic will be marked with a new QoS value appropriate for the policy in place at the point where the traffic entered the campus network.
E.Trust boundaries define the firewall rules for QoS admission into a network.
Refer to the exhibit. Based upon the information that is given,
how will voice traffic from the phone and data traffic from the PC be handled by SW_1? ()
A.The switch port will perform marking for the ingress voice and data traffic by using the defaultCoS value at the switch port.
B.The switch port will trust theCoS value of the ingress voice and data traffic that comes into the switch port.
C.The switch port will trust theCoS value of the ingress voice traffic. Data traffic will be marked at the switch port with the default CoS value.
D.The switch port will trust theCoS value of the ingress data traffic. Voice traffic will be marked at the switch port with the default CoS value.
The voice VLAN feature has been enabled on a new Company Catalyst switch port.
What is the effect of this? ()
A.The CoS is trusted for 802.1P or 802.1Q tagged traffic.
B.PortFast is disabled on the port.
C.Port Security is automatically enabled on a voice VLAN port.
D.Untagged traffic is sent according to the default CoS priority of the port.
E.None of the other alternatives apply
Refer to the exhibit.
Which statement is true about where trust boundaries should be established in a network?()
A.Endpoints 2 and 3 are optimal places to establish a trust boundary. Endpoint 1 is an acceptable place to establish a trust boundary.
B.Endpoint 2 is the optimal place to establish a trust boundary. Endpoints 1 and 3 are acceptable places to establish a trust boundary.
C.Endpoint 2 is the only acceptable place to establish a trust boundary.
D.Endpoint 1 is the only acceptable place to establish a trust boundary.
E.Endpoints 1 and 2 are optimal places to establish a trust boundary. Endpoint 3 is an acceptable place to establish a trust boundary.
F.Endpoint 1 is the optimal place to establish a trust boundary. Endpoints 2 and 3 are acceptable places to establish a trust boundary.
最新試題
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Which statement is correct about RSTP port roles?()
During routine maintenance, it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time, DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ? ()
During routine maintenance, G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ? ()
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?()
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?()
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()
What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)?()
Refer to the exhibit. Which Virtual Router Redundancy Protocol (VRRP) statement is true about the roles of the master virtual router and the backup virtual router?()
Which two statements are true when the extended system ID feature is enabled? ()