A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.
您可能感興趣的試卷
你可能感興趣的試題
A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash
A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST.
You are unable to connect to the TESTKING1 router. Which of the following command sequences will correct this problem?()
A.
B.
C.
D.
E.
F.
You want the text "Unauthorized access prohibited!" to be displayed before the login prompt every time someone tries to initiate a Telnet session to a router, as shown in the example below:
Which command can be used to configure this message?()
A. login banner x Unauthorized access prohibited! X
B. banner exec y Unauthorized access prohibited! Y
C. banner motd x Unauthorized access prohibited! X
D. vtv motd "Unauthorized access prohibited!"
The TestKingA router is configured as shown below:
TestKingA(config)# interface loopback 0
TestKingA(config-if)# ip address 192.168.16.24 255.255.255.255
As a result of this change, which of the statements below are true?()
A. It creates a virtual, software only, interface.
B. It provides a way to test the convergence of OSPF routing updates.
C. The mask of 255.255.255.255 is called a host mask.
D. It uses a wildcard mask of 255.255.255.255.
E. It ensures that an interface is always active for OSPF processes.
F. Loopback interfaces must be numbered 0.
A CCNA candidate is working on a 2600 Cisco router. The person needs to verify that the configuration register is set to boot the router IOS from flash memory and use the commands saved in the startup-configuration file.
Which command will display this information, and what is the configuration register value that should be displayed?()
A. show startup-config and 0x2142
B. show version and 0x2102
C. show flash and 0x2102
D. show version and 0x2142
E. show running-config and 0x2142
F. show flash and 0x2142
A. Make sure that the server can be reached across the network.
B. Check the authentication for TFTP access to the server is set.
C. Assure that the network server as adequate space for the IOS image.
D. Verify file naming and path requirements.
E. Make sure that the server can store binary files.
F. Adjust the TCP window size to speed up the transfer.
A Cisco router has been configured, and the copy running-config startup-config command has been issued. When the router is power cycled, the router prompts with:
"Would you like to enter the initial configuration dialog? [yes/no]"
Why has this occurred?()
A. There is an error in the router DRAM.
B. Te IOS image is corrupt.
C. The configuration register is set to 0x2142.
D. The TFTP server that contains the router configuration file is unreachable.
E. A boot system configuration command has placed the router into setup mode.
最新試題
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?()
How many usable sub network and usable hosts per subnet result in the network address 201.105.13.0 is sub netted with a mask of /26? ()
Which of the following statements regarding routed and routing protocols are true?()
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? ()
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()
Which connections allow the use of full-duplex Ethernet?()
Which of the following correctly describe steps in the OSI data encapsulation process?()
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?()
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?()