A. To configure a route to the first Layer 3 device on the network segment.
B. To configure a route from an ISP router into a corporate network.
C. To configure a route when the administrative distance of the current routing protocolis too low.
D. To reach a network is more than 15 hops away.
E. To provide access to the Internet for enterprise hosts.
您可能感興趣的試卷
你可能感興趣的試題
A. router(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1
B. router(config)# ip default-route 10.1.1.0
C. router(config)# ip default-gateway 10.1.1.0
D. router(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1
A.
B.
C.
D.
E.
F.
A. It is globally enabled by default on Cisco routers.
B. It is globally enabled by default on all routers.
C. It is a proprietary protocol.
D. It is a non-proprietary protocol.
E. It can be used to gather hardware and protocol information about neighbor devices.
A. The Frame Relay encapsulation on the physical interface.
B. The local DLCI on each subinterface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point.
A.close
B.disable
C.disconnect
D.suspend
E.exit
F.None of the above
The Testking Network consists of the following 5 IP networks:
NETWORK 1: 192.168.10.0/26
NETWORK 2: 192.168.10.64/27
NETWORK 3: 192.168.10.96/27
NETWORK 4: 192.168.10.128/30
NETWORK 5: 192.168.10.132/30
Which of the following routing protocols will support this IP addressing scheme?()
A. RIP version 1
B. RIP version 2
C. IGRP
D. EIGRP
E. OSPF
F. BGP
A. CIDR
B. Split horizon
C. Authentication
D. Classless masking
E. Hold-down timers
F. Multicast routing updates
G. Path Vectoring
You need to implement the use of a routing protocol that meets the following
requirements:
1. Converges quickly
2. Supports VLSM, CIDR, IP, and IPX.
3. Uses minimal bandwidth for routing updates.
Which one of the following routing protocols would be the best choice?()
A. RIPv1
B. RIPv2
C. IGRP
D. OSPF
E. EIGRP
A. RIPv1
B. IGRP
C. EIGRP
D. OSPF
E. IS-IS
F. RIPv2
A. RIPv1
B. EIGRP
C. OSPF
D. IGRP
E. RIPv2
最新試題
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?()
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?()
Which characteristics are representative of a link-state routing protocol?()
How many usable sub network and usable hosts per subnet result in the network address 201.105.13.0 is sub netted with a mask of /26? ()
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?()
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?()
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. ()
What is the subnetwork address for a host with IP address 201.100.5.68/28?()
Which of the following host addresses are member of networks that can be routed across the public Internet? ()
Which of the following options lists the steps in PPP session establishment in the correct order?()