A. RX-queue deferred
B. TX-queue deferred
C. RX-queue saturation
D. TX-queue saturation
E. RX-queue starvation
F. TX-queue starvation
您可能感興趣的試卷
你可能感興趣的試題
Which two practices will avoid Cisco Express Forwarding polarization?()
A. The core layer should use default Layer 3 hash information.
B. The core layer should use default Layer 4 hash information.
C. The distribution layer should use default Layer 3 hash information.
D. The distribution layer should use default Layer 4 hash information.
E. The core layer should use Layer 3 and Layer 4 information as input to the Cisco Expressing Forwarding hashing algorithm.
F. The distribution layer should use Layer 3 and Layer 4 information as input into the Cisco Expressing Forwarding hashing algorithm.
A. Voice needs to be assigned to the hardware priority queue.
B. Voice needs to be assigned to the software priority queue.
C. Call signaling must have guaranteed bandwidth service.
D. Strict-priority queuing should be limited to 50 percent of the capacity of the link.
E. At least 33 percent of the link bandwidth should be reserved for default best-effort class.
A.CST
B.MST
C.STP
D.PVST+
E.RPVST+
A. to ensure a loop-free topology
B. to protect against user-side loops
C. when a VLAN spans access layer switches
D. for the most deterministic and highly available network topology
E. because of the risk of lost connectivity without Spanning Tree Protocol
Refer to the exhibit. Which recommended practice is applicable?()
A. If no core layer is deployed, the design will be easier to scale.
B. If no core layer is deployed, there will be fewer cabling requirements.
C. If no core layer is deployed, the distribution switches should not be fully meshed.
D. A dedicated campus core layer is not needed for connecting fewer than five buildings.
E. A dedicated campus core layer should be deployed for connecting three or more buildings.
A. Utilize Layer 3 switching.
B. Utilize software accelerated services.
C. Aggregate end users and support a feature-rich environment.
D. Perform packet manipulation and filtering at the core layer.
E. Use redundant point-to-point Layer 2 interconnections when there is a link or node failure.
A. Routing is mostly static.
B. Hardcoded IP addresses are used to support failover.
C. Inbound servers use the CSM or ACE as the default gateway.
D. VLANs between the access layer switches are used for FHRP protocols.
A. single run
B. multi-homed
C. stub domain EBGP
D. direct BGP peering
A. An interface can only belong to single Flex Links.
B. An interface can belong to multiple Flex Links.
C. Flex Links operate only over single pairs of links.
D. Flex Links automatically disable STP so no BPDUs are propagated.
A. load balancing
B. scalability
C. remote management
D. fault tolerance
E. service assurance
最新試題
You are the Cisco Network Designer. Which of these is least important when determining how many users a NAS can support?()
What amount of cell overlap ensures smooth roaming for wireless endpoints?()
As an experienced technician, you are responsible for Technical Support. A customer calls to ask the best signal level and noise level for cell phone. How to respond?()
During consultation, you find that a customer has multiple asset closets and will be adding more in the future. Which NAS physical deployment model would you suggest to this customer?()
Cisco Express Forwarding (CEF) is mainly used to increase packet switching speed, reducing the overhead and delays introduced by other routing techniques, increasing overall performance.Which of the following concerning CEF is recommended by Cisco?()
What is the recommended practice when considering VPN termination and firewall placement?()
One of your customers has deployed a Layer 3 gateway in the untrusted network. Which gateway mode is appropriate for this customer?()
Refer to the exhibit. Which two statements about the topologies shown are correct?()
Which of the following is the primary consideration to scale VPNs?()
Which of these is true of a Layer 3 out-of-band NAS deployment?()