A. it is a layer 2 messaging protocol which maintains vlan configurations across network.
B. it includes an 8-bit field which specifies the priority of a frame.
C. it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D. it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E. it is a trunking protocol capable of carring untagged frames.
您可能感興趣的試卷
你可能感興趣的試題
A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC
A. Microsegmentation decreases the number of collisions on the network.
B. if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C. Spanning Tree Protocol allows switches to automatically share vlan information.
D. In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E. Establishing vlans increases the number of broadcast domains.
F. Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.
A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan
A. Router(config)#router ospf 1
B. Router(config)#router ospf 0
C. Router(config)#router ospf area 0
D. Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E. Router(config-router)#network 192.168.16.0 0.0.0.255 0
F. Router(config-router)#network 192.168.16.0 255.255.255.0 area 0
A. RIP requires less time to converge
B. RIP uses less bandwidth
C. RIP is less complex to configure
D. RIP demands fewer router resources
E. RIP has a more accurate metric
A. one IP network or subnetwork for each subinterface
B. subinterface numbering that matches vlan tages
C. subinterface encapsulation identifiers that match vlan tags
D. a management domain for each subinterface
E. one physical interface for each subinterface
F. one subinterface per vlan
A. A CSU/DSU terminates a digital local loop
B. A modem terminates a digital local loop
C. A CSU/DSU terminates an analog local loop
D. A modem terminates an analog local loop
E. A router is commonly considered a DTE device
F. A router is commonly considered a DCE device
A. can be used over analog circuits
B. maps Layer 2 to Layer 3 address
C. encapsulates several routed protocols
D. supports IP only
E. provides error correction
A. Administratively shut down the interfaces.
B. Physically secure the interfaces.
C. Configure a virtual terminal password and login process.
D. Enter an access list and apply it to the terminal interfaces using the access-class command.
E. Create an access list and apply it to the terminal interfaces using the access-group command.
A.multicast
B.broadcast
C.allcast
D.podcast
E.anycast
最新試題
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
Which command displays the CHAP authentication process as it occurs between two routers?()
Which statement is true, as relates to classful or classless routing?()