A.the OSPF route
B.the EIGRP route
C.the RIPv2 route
D.all three routes
E.the OSPF and RIPv2 routes
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.A new subnet with 60 hosts has been added to the network.Which subnet address should this network use to provide enough usable addresses while wasting the fewest addresses?（）
A.192.168.1.56/27
B.192.168.1.64/26
C.192.168.1.64/27
D.192.168.1.56/26
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?（）
A.VLANs have not been created yet
B.An IP address must be configured for the port
C.The port is currently configured for access mode
D.The correct encapsulation type has not been configured
E.The no shutdown command has not been entered for the port
A.by encrypting all passwords passing through the router
B.by encrypting passwords in the plain text configuration file
C.by requiring entry of encrypted passwords for access to the device
D.by configuring an MD5 encrypted key to be used by routing protocols to validate routing exchanges
E.by automatically suggesting encrypted passwords for use in configuring the router
Refer to the exhibit. The company uses EIGRP as the routing protocol. What path will packets take from a host on 192.168.10.192/26 network to a host on the LAN attached to router R1?（）
A.The path of the packets will be R3 to R2 to R1.
B.The path of the packets will be R3 to R1 to R2.
C.The path of the packets will be both R3 to R2 to R1 and R3 to R1.
D.The path of the packets will be R3 to R1
Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but they are unable to communicate. The Atlanta router is known to have the correct configuration.Given the partial configurations, identify the fault on the Brevard router that is causing the lack of connectivity？（）
A.incompatible IP address
B.insufficient bandwidth
C.incorrect subnet mask
D.incompatible encapsulation
E.link reliability too low
F.IP/TCP closed
A.to map a known DLCI to an IP address
B.to map a known IP address to a MAC address
C.to map known SPID to a MACaddress
D.to map a known DLCI to a MAC address
E.to map a known IP address to a SPID
F.to map a known MAC address to an IP address
A.show frame-relay end-to-end
B.show frame-relay map
C.show frame-relay lmi
D.show frame-relay pvc
A.They create split-horizon issues
B.They require a unique subnet within a routing domain
C.They emulate leased lines
D.They are ideal for full-mesh topologies
E.They require the use of NBMA options when using OSPF
A. NCP
B. LCP
C.ISDN
D.DLCI
E.SLIP
A.defines the source IP address that is used in all broadcast packets on DLCI 202
B.defines the DLCI that is used for all packets that are sent to the 192.168.1.2 IP address
C.defines the destination IP address that is used in all broadcast packets on DLCI 202
D.defines the DLCI on which packets from the 192.168.1.2 IP address are received
最新試題
Which is true about OSPF router-id?（）
Which three features are added in SNMPv3 over SNMPv2? （）
In a GLBP network, who is responsible for the arp request?（）
Which one of these is a valid HSRP Virtual Mac Address?（）
What command visualizes the general NetFlow data on the command line?（）
Which three features are added in SNMPv3 over SNMPv2 ? （）
Refer to the exhibit.If the devices produced the given output,what is the cause of the EtherChannel problem?（）
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?（）
What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance?（）
What are three reasons to collect Netflow data on a company network?（）