單項選擇題Assuming the default switch configuration,which approach should you use to configure the extended vlan range(1006 through 4094) on a cisco catalyst 3750 series switch?()

A.Configure the switch to be in VTP client mode.
B.Configure the switch to be in VTP domaint mode.
C.Configure the switch to be in VTP transparent mode.
D.Configure the switch to be in VTPv2.


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which two commands can be used to verify a trunk link configurationt status on a given cisco switch?()

A.show interfaces interface
B.show interfaces interface trunk
C.show interfaces interface switchport
D.show ip interface brief
E.show interfaces vlan

4.單項選擇題The enable secret command is used to secure access to which CLI mode?()

A.user EXEC mode
B.global configuration mode
C.privileged EXEC mode
D.auxiliary setup mode

5.多項選擇題Which commands are required to properly configure a router to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?()

A.Router(config)#router ospf 1
B.Router(config)#router ospf 0
C.Router(config)#router ospf area 0
D.Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E.Router(config-router)#network 192.168.16.0 0.0.0.255 0
F.Router(config-router)#network 192.168.16.0 255.255.255.0 area 0

6.單項選擇題

Refer to the exhibit.S0/0 on R1 is configured as a multipoint interface to communicate with R2 and R3 in the hub-and-spoke Frame Relay topology. While testing this configuration, a technician notes that pings are successfully from hosts on the 172.16.1.0/24 network to hosts on both the 172.16.2.0/25 and 172.16.0.2.128/25 networks. However, pings between hosts on the 172.16.2.0/25 and 172.16.2.128/25 network are not successful. What could explain this connectivity problem?()

A.The ip subnet-zero command has been issued on the R1 router.
B.The RIPv2 dynamic routing protocol cannot be used across a Frame Relay network.
C.Split horizon is preventing R2 from learning about the R3 networks and R3 from learning about R2 networks.
D.The 172.16.2.0/25 and 172.16.2.128/25 networks are overlapping networks that can be seen by R1,but not between R2 and R3.
E.The 172.16.3.0/29 network used on the Frame Relay links is creating a discontiguous network between the R2 and R3 router subnetworks.

7.單項選擇題Which statement about vlan operation on cisco catalyst switches is true?()

A.when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table
B.unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C.ports between switches should be configured in access mode so that vlans can span across the ports
D.broadcast and multicast frames are retransmitted to ports that are configured on different vlan.

8.單項選擇題What is an appropriate use of a default route?()

A.to provide routing to a local web server
B.to provide routing from an ISP to a stub network
C.to provide routing that will override the configured dynamic routing protocol
D.to provide routing to a destination that is not specified in the routing table and which is outside the local network

9.多項選擇題Which two statements describe the advantages to the use of RIP over the use of OSPF?()

A.RIP requires less time to converge
B.RIP uses less bandwidth
C.RIP is less complex to configure
D.RIP demands fewer router resources
E.RIP has a more accurate metric

10.單項選擇題What is valid reason for a switch to deny port access to new devices when port security is enabled? ()

A.The denied MAC addresses have already been learned or confgured on another secure interface in the same VLAN.
B.The denied MAC address are statically configured on the port.
C.The minimum MAC threshold has been reached.
D.The absolute aging times for the denied MAC addresses have expired.

最新試題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()

題型:多項選擇題

請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()

題型:多項選擇題

路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()

題型:單項選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:單項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€廣播域?()

題型:單項選擇題

傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()

題型:單項選擇題

要將數據包發送到遠程網絡,應使用哪種設備?()

題型:單項選擇題

請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()

題型:單項選擇題

請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()

題型:單項選擇題

請參見圖示。下列哪組設備僅包含中間設備?()

題型:單項選擇題