單項選擇題在IEEE802.11b無線局域網規范中,指定的最高數據速率是?()

A.10Mbps
B.11Mbps
C.54Mbps
D.100Mbps


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

圖中所示網絡運行RIPV2路由選擇協議,全網收斂并且所有的路由器運行正常?,F(xiàn)在R1的FastEthernet0/0端口,不能正常工作了,則網段內的路由器會作出怎樣的回應?()

A.所有的路由器會參照自己的拓?fù)鋽?shù)據庫,看它們是否有到192.168.1.0的備份路由。
B.R2和R3會標記到192.168.1.0的路由為不可用,并且不會從R1接受更新直到它們的抑制定時器超時
C.由于水平分割原則,R2不會向R1發送關于去往192.168.1.0網段的錯誤信息
D.當R2從R1那里學到192.168.1.0網段不可達時,R2把去往192.168.1.0網段的度量值設置為無限大,并向R1發送回應消息。
E.R1將會發送LSA給R2和R3通知它們網絡的變化情況,然后所有的路由器周期性的遞增的發送更新直到網絡收斂。

2.單項選擇題A network administrator receives an error message while tring to configure the Ethernet interface of a router with IP address 10.24.24.24/29.which statement explains the reason for this issue?()

A.The address is a broadcast address
B.The Ehernet interface is faulty
C.VLSM-capable routing protocols must be enable first on the router.
D.This address is a network address.

3.單項選擇題

Th efollowing access list below was applied outbound on the E0 interface connected to the 192.169.1.8/29LAN:
access-list 135 deny tcp 192.169.1.80.0.0.7 eq 20 any
access-list 135 deny tcp 192.169.1.80.0.0.7 e q21 any
How will the above access lists affect traffic?()

A.FTP traffic from 192.169.1.22 wil lbe denied
B.Not raffic,except for FTP traffic wil lbe allowed to exit E0
C.FTP traffic from 192.169.1.9 to any host will be denied
D.All traffic exiting E0 will be denied
E.All FTP traffic to network 192.169.1.9/29 will be denied

5.單項選擇題在OSPF點到點鏈路中,Hello包是發往以下那個地址?()

A.127.0.0.1
B.172.16.0.1
C.192.168.0.5
D.223.0.0.1
E.224.0.0.5
F.254.255.255.255

6.單項選擇題

根據下圖,假設路由器已經配置了默認配置,那么這個接口是()。

A.Ethernet
B.Fast Ethernet
C.Gigabit Ethernet
D.asynchronous serial
E.synchronous serial

7.多項選擇題Why do large OSPF networks use a hierarchical design?()

A.to confine network instability to single areas of the network.
B.to reduce the complexity of router configuration
C.to speed up convergence
D.to lower costs by replacing routers with distribution layer switches
E.to decrease latency by increasing bandwidth
F.to reduce routing overhead

9.多項選擇題

Host1正在試圖和Host2聯系。RouterC的e0接口是down的,以下選項正確的是?()


A.RouterC會使用ICMP通知Host1“Host2無法到達”
B.RouterC會使用ICMP通知Host1“Host1無法到達”
C.RouterC會使用ICMP通知Host1,RouterA和RouterB“Host2無法到達”
D.RouterC會發送一個“DestinationUnreachable”的消息類型
E.RouterC會發送一個“RouterSelection”的消息類型
F.RouterC會發送一個“SourceQuench”的消息類型

10.單項選擇題How many subnets can be gained by subnetting 172.17.32.0/23 into a /27 mask, and how many usable host addresses will there be per subnet?()

A.8 subnets, 31 hosts
B.8 subnets, 32 hosts
C.16 subnets, 30 hosts
D.16 subnets, 32 hosts
E.A Class B address can't be subnetted into the fourth octet.

最新試題

請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()

題型:單項選擇題

請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()

題型:多項選擇題

何時必須使用clock rate 命令配置路由器串行接口?()

題型:單項選擇題

請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()

題型:單項選擇題

OSI 模型的哪兩項功能在第2層實現?()

題型:多項選擇題

請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()

題型:單項選擇題

請參見圖示。下列哪組設備僅包含中間設備?()

題型:單項選擇題

以下哪兩種介質可提供高達1Gb/s 的帶寬?()

題型:多項選擇題

請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()

題型:多項選擇題

請參見圖示。對于從主機A 向Web 服務器發出的網頁請求,正確的目的套接字?jǐn)?shù)字是什么?()

題型:單項選擇題